Filter
Top Products
OA 5000 Series User Manual 2 --- 9
Setting the GPIB Address
Setting the GPIB address is accomplished using the ADDR (SET) button
and the LEVEL ADJUST knobs (Figure 2-4).
DISABLE
MIN ATT
STORE 1 RECALL 1
STORE 2 RECALL 2
REMOTE MODE
SET REF
COARSE
FINE
WAVE---
LENGTH
ADDR
(SET)
Turning either knob
changes the GPIB
address (when the
ADDR button is lit).
This button assigns
the knobs to set the
GPIB address.
Figure 2-4: The Location of the ADDR (SET) Button
To set the GPIB address:
Step 1: Press the ADDR (SET) button so that it is lighted. The ATTEN-
UATION display will change to read Addr and the GPIB address will be
displayed in the WAVELENGTH display.
Step 2: Use either the COARSE or FINE knobs to change the address.
Step 3: When the address is set, press the ADDR (SET) button again
to enter the change of address.
The ADDR (SET) button also indicates the addressed status of the OA 5000
from the GPIB (when the GPIB address is not being set). When the button is
lit, the OA 5000 has been addressed to talk or listen by a controller on the
GPIB.