Filter
Top Products
OA 5000 Series User Manual 2 --- 15
Storing and Recalling
Attenuation Levels
The OA 5000 can store two attenuation levels for later recall. This can help
save you time and minimize mistakes. Refer to Figure 2-6.
DISABLE
MIN ATT
STORE 1 RECALL 1
STORE 2 RECALL 2
These buttons store
and recall attenuation
settings.
Figure 2-6: The Location of the STORE and RECALL Buttons
To store an attenuation setting
H press either STORE1 or STORE2.
The current attenuation setting will be stored. The ATTENUATION display
will blink once to indicate acceptance of the value.
NOTE
When you press STORE1 or STORE2, the only setting saved is the
attenuation setting. The wavelength setting is not stored. If the
wavelength of your signal has changed since the attenuation setting
was stored, you will have to adjust the wavelength setting to ensure
accurate attenuation.
To recall an attenuation setting
H press either RECALL1 or RECALL2.
The selected setting will be recalled.