Filter
Top Products
Commands
Programming
3 --- 14
Table 3-4: Commands Common to All GPIB Devices and
Supported by the OA 5000 Series (Cont.)
Header Ful l Command Name
FACTory Set to Factory Defaults
HEADer Header
*IDN? Identification
*LRN? Learn Device Setup
*OPC Operation Complete
*PSC Power-On Status Clear
*RST Reset
*SRE Service Request Enable
*STB? Read Status Byte
*TST? Self-Test
VERBOSE Verbose
*WAI Wait To Continue
1
*CAL? always returns 0.
Table 3-5 lists the device commands, queries, and command parameters
that are specific to the OA 5000. Complete descriptions of these commands
appear in the alphabetical listing of commands that immediately follows this
table.
Table 3-5: OA 5000 Device Commands and Parameters
Header
Full Command Name
ADJusting? Attenuator Adjusting
ATTen Attenuation
ATTen:DB Attenuation in Absolute Terms
ATTen:DBR Attenuation with Reference Value
ATTen:MIN Minimum Attenuation
DISable Light Shutter Status
DISPlay Front Panel Display Mode
RECall Recall Attenuation Setting
Device Commands
and Queries