Filter
Top Products
DUA1800-0AAA04
LinkBuilder ECS Modules 3-25
5
Make sure that the converter is securely fitted to the module.
Engage the module into the slot, using just sufficient force to
ensure that the connector on the edge of the converter mates
with the socket on the MSH backplane.
6
Locate the two round-headed screws supplied as part of the
module assembly, in the tapped holes at the top and bottom of
the module. Tighten the screws.
7
Reposition the locking bar and tighten the two screws to secure it
in place.
Removing An ECS Module From The MSH Chassis
1
Remove all network connections from the module that will be
removed.
2
Remove the locking bar from the front of the chassis.
3
Remove the round-headed screws from the top and bottom of
the module. Carefully withdraw the module from the chassis. The
converter should come out with it; if it does not, contact your
supplier for advice.
4
If you do not intend to fit a replacement module immediately, you
must cover the vacant slot with a blanking plate. This prevents
dust from entering the chassis and helps the circulation of cooling
air. See
Blanking Plates
on page 3-16
5
Reposition the locking bar and tighten the two screws to secure it
in place.
6
If necessary remove the converter from the module.
Chassis.bk : CHAPTER3 Page 25 Monday, February 10, 1997 1:11 PM