Filter
Top Products
4-6 C
HAPTER
4: U
SING
T
HE
D
ISPLAY
P
ANEL
DUA1800-0AAA04
Resetting The LinkBuilder MSH
The display panel carries a facility for resetting the LinkBuilder
MSH. This operation restarts the entire MSH chassis, including the
display panel and installed modules.
1
Press and hold down the Reset button and Enter button at the
same time. The Reset operation will only be performed if these
two buttons are pressed simultaneously; this protects against
accidental system resets.
2
Release the two buttons; the MSH will reset and then continue to
operate normally in its current configuration.
Token rings and secure Ethernet modules will be taken out of
operation for a several seconds after which they will reconfigure
and operate normally.
Management
In order to carry out management of the LinkBuilder MSH, you
must install a LinkBuilder Management Module into the chassis.
Management is applied in one of the three ways quoted below.
The LinkBuilder MSH Management Module can be installed into
any slot within the MSH chassis. We recommend that you use slot
11 for the Management Module leaving the maximum number of
slots free for ECS modules. ECS modules must not be installed in
this position.
The Four-button Keypad
The LCD panel and the adjacent four-button keypad located on
the display panel, allow you access to read-only information
which tells you about the current setup of the chassis. For full
instructions on using the keypad, you will need to refer to the
user guides that accompany the Management Module.
Chassis.bk : CHAPTER4 Page 6 Monday, February 10, 1997 1:11 PM