Filter
Top Products
Error Messages - C
105
Table C-1. Error Numbers (continued
Selftest Errors 0 through 99 (sets Standard Event Status Register bit #3)
0 No error
1 Output 1 non-volatile RAM CAL section checksum failed
2 Output 2 non-volatile RAM CAL section checksum failed
3 Output 3 non-volatile RAM CAL section checksum failed
4 Output 4 non-volatile RAM CAL section checksum failed
5 Non-volatile RAM CONFIG section checksum failed
10 RAM selftest
Device-Dependent Errors 100 through 32767 (sets Standard Event Status Register bit #3)
100 Flash write error
101 Flash erase error
401 CAL switch prevents calibration
402 CAL password is incorrect
403 CAL not enabled
404 Computed readback cal constants are incorrect
405 Computed programming cal constants are incorrect
406 Incorrect sequence of calibration commands
407 CV or CC status is incorrect for this command
601 Too many sweep points
603 CURRent or VOLTage fetch incompatible with last acquisition
604 Measurement overrange
607 Operation not allowed with the present language setting
608 Valid only while the output is disabled
609 No data in acquisition buffer
610 Bad update data
611 Not in update state
900 Bad binary mode call packet checksum
901 Bad binary mode protocol version
902 Bad binary mode function number
903 Bad binary mode channel list
950 Bad binary mode reply packet checksum
951 Bad binary mode transaction ID