Filter
Top Products
1 - General Information
14
Options and Accessories
Table 1-1. Options
Option Description
100
87−106 Vac, 47−63 Hz
220
191−233 Vac, 47−63 Hz
230
207−253 Vac, 47−63 Hz
8ZL Add instrument feet - for bench mounting (p/n 5041-9167)
AXS
1
Rack mount kit for two side-by-side N3280A units. Consists of:
Lock-link kit (p/n 5061-9694), Flange kit (p/n 5063-9212), Tie bracket (p/n 5002-1587)
1CM
1
Rack mount kit for one unit (p/n 5063-9240)
1
Support rails are required when rack mounting units. Use E3663A support rails for Agilent rack cabinets. If you are
using non-Agilent rack cabinets, contact the rack manufacturer to obtain support rails for your cabinet.
Table 1-2. Accessories
Item Part Number
GPIB cables 1.0 meter (3.3 ft) Agilent 10833A
2.0 meters (6.6 ft) Agilent 10833B
4.0 meters (13.2 ft) Agilent 10833C
0.5 meters (1.6 ft) Agilent 10833D
Rack mount with slide - for two side-by-side units Order 5063-9255 and 1494-0015
Rack mount with slide - for one unit Order 5063-9255, 1494-0015, and 5002-3999
Description
The Agilent Model N3280A Component Test DC Source is a quad output dc power supply designed to
simplify the testing of integrated circuits. It has the following key features and performance capabilities:
♦ High density – four isolated outputs in a 2U half-rack package
♦ Four quadrant bipolar output
♦ High programming and measurement accuracy (refer to Appendix A)
♦ Active guard available for accurate current measurements
♦ Solid-state output and sense terminal disconnect relays
♦ High GPIB throughput
Additional features include:
♦ Positive and negative overvoltage protection shutdown
♦ Over-temperature and oscillation protection
♦ Programmable current limit in voltage priority mode
Remote Programming
NOTE: With the exception of the power switch, there are no front panel controls for the Agilent
N3280A dc source. The N3280A can be controlled only with SCPI programming commands.
The dc source may be remotely programmed via the GPIB bus. GPIB programming is with SCPI
commands (Standard Commands for Programmable Instruments), which make dc source programs
compatible with those of other GPIB instruments. Dc source status registers allow remote monitoring of a
wide variety of operating conditions. Refer to chapters 5 and 6 for more information.