Filter
Top Products
118 Brocade BigIron RX Series Hardware Installation Guide
53-1002483-03
Replacing cooling system components
5
• An ESD wrist strap with a plug for connection to the ESD connector on the BigIron RX Series
chassis
DANGER
For safety reasons, the ESD wrist strap should contain a 1 meg ohm series resistor.
Follow the steps given below to replace a fan assembly in the BigIron RX-4 and BigIron RX-8.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector
located in the upper right corner of the chassis rear.
2. Push down on the latch release with your thumb.
3. Remove the fan assembly from the chassis by grabbing the handle on the fan assembly and
pulling it toward you as shown in Figure 44 and Figure 45. Pulling the enclosure unseats the
fan assembly connector from a chassis connector.
DANGER
Be careful not to insert your fingers into the fan while removing it from the chassis. The fan may
still be spinning at a high speed.
FIGURE 44 Removing a fan from a BigIron RX-4 switch
1 Latch release 2 Fan tray assembly
1
2