Filter
Top Products
Brocade BigIron RX Series Hardware Installation Guide 9
53-1002483-03
Hardware features
1
Interface modules
You can install up to 16 BigIron RX Series interface modules in the BigIron RX Series chassis as
described:
• BigIron RX-4: Supports up to 4 interface modules
• BigIron RX-8: Supports up to 8 interface modules
• BigIron RX-16: Supports up to 16 interface modules
NOTE
A BigIron RX Series interface module is dedicated, which means that you must install it in the BigIron
RX Series chassis only. If you attempt to install a BigIron RX Series interface module in another
Brocade chassis or an interface module intended for another Brocade chassis in the BigIron RX
Series chassis, the module will not boot up to become active. Interface modules can be shared
between BigIron RX-4, BigIron RX-8, and BigIron RX-16.
The interface modules are hot swappable, which means you can remove and replace them without
powering down the system.
4-port 10 Gigabit Ethernet module
Figure 5 shows the 4-port 10 Gigabit Ethernet module’s front panel with XFP modules installed.
FIGURE 5 4-port 10 Gigabit Ethernet module front panel
The front panel includes the following control features:
• Four LEDs
• Four 10 Gigabit Ethernet XFP slots
LEDs
The module’s front panel includes two LEDs that indicate the status of each port.
Table 2 describes the LEDs on the 10 Gigabit Ethernet module’s front panel.
10/100/100
0 Ethernet
Port
Above and right
of RJ-45
connector
On (Green) A link is established with the remote port.
Off A link is not established with the remote port.
10/100/100
0 Ethernet
Port
Above and left of
RJ-45 connector
On or blinking
(Yellow)
The port is transmitting and receiving packets.
Off for an
extended period
The port is not transmitting or receiving packets.
TABLE 1 Management module LEDs (Continued)
LED Position State Meaning