Filter
Top Products
Brocade BigIron RX Series Hardware Installation Guide 57
53-1002483-03
Verifying proper operation
2
TABLE 13 Desired and abnormal LED states after system power on
LED Desired state Meaning Abnormal
state
Meaning or action
Management module
Active The Active LED on
one of the installed
management
modules should be
on.
The module is
functioning as the
active management
module.
Off Neither of the management
modules is managing the switch
fabric and interface modules.
A problem could have occurred
during initialization. Check your
attached PC or terminal for
possible error messages.
Pwr On The module is
receiving power.
Off The module is not receiving power.
You can do the following:
• Make certain that the
module is installed properly.
For more information, refer to
“Installing BigIron RX-4
modules” on page 28,
“Installing BigIron RX-8
modules” on page 38, and
“Installing BigIron RX-16
modules” on page 48.
• If using AC power supplies,
see the entry for the AC
power supply LED in this
table for more information.
10/100/1000
Ethernet Port
On (Green) A link is established
with the remote port.
Off A link is not established with the
remote port. You can do the
following:
• Verify that the connection to
the other device has been
properly made. Also, make
certain that the other device
is powered on and operating
correctly.
• Try using a different cable.
10/100/1000
Ethernet Port
On or blinking
(Yellow)
The port is
transmitting and
receiving packets.
Off for an
extended
period
The port is not transmitting or
receiving packets.
You can check the other
10/100/1000 Ethernet port LED
to make sure a link is established
with the remote port. If not, take
the actions described in the
Meaning or Action column for the
other 10/100/1000 Ethernet port
LED.