Filter
Top Products
Brocade BigIron RX Series Hardware Installation Guide 69
53-1002483-03
Configuring IP addresses
3
Assigning an IP address to a management interface
Instead of assigning a global IP address to the BigIron RX Series switch for system management
purposes, you now assign an IP address to the management interface. The IP address is assigned
to the active management module port. If the active management module becomes unavailable
and the redundant module becomes the active module, the IP address is assigned to the new
active management module port.
For example, to assign the IP address 10.0.1.1 to the management interface, do the following:
1. At the opening CLI prompt, enter enable.
BigIron RX> enable
2. Enter the following command at the Privileged EXEC level prompt (for example, BigIron RX#),
then press Enter. This command erases the factory test configuration if still present:
BigIron RX# erase startup-config
CAUTION
Use the erase startup-config command only for new systems. If you enter this command on a
system you have already configured, the command erases the configuration. If you accidentally
erase the configuration on a configured system, enter the write memory command to save the
running configuration to the startup-config file.
3. Access the configuration level of the CLI by entering the following command:
BigIron RX# configure terminal Privileged EXEC Level
BigIron RX(config)# Global CONFIG Level
4. Configure the IP address and mask for the management interface by entering the following
commands:
BigIron RX(config)# interface management 1
BigIron RX(config-if-mgmt-1)# ip address 10.0.1.1 255.255.255.0
Syntax: enable [<password>]
Syntax: configure terminal
Syntax: interface management 1
Syntax: [no] ip address <ip-addr> <ip-mask>
or
Syntax: [no] ip address <ip-addr>/<mask-bits>
Assigning an IP address to an interface, virtual Interface,
or loopback
As you have done with other Brocade devices, you must assign an IP address to each interface and
virtual interface over which user packets are routed. You can also assign an IP address to a
loopback interface, which is generally used for testing and diagnostic purposes.