Filter
Top Products
Brocade BigIron RX Series Hardware Installation Guide 51
53-1002483-03
Installing a BigIron RX-16 switch
2
FIGURE 34 Installing a power supply in a BigIron RX-16 chassis
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
4. After the power supply is fully inserted, push the power supply front panel toward the back of
the chassis. This action causes the power supply connector to latch into the backplane
connector.
5. For information about connecting power to the chassis, refer to “Connecting AC power to a
BigIron RX-16 chassis” below.
6. For information about powering on the system, refer to “Powering-on the power source” on
page 55.
Connecting AC power to a BigIron RX-16 chassis
AC power is supplied through an AC power cord that is installed at the rear of the BigIron RX-16
chassis.
1. At the rear of the BigIron RX-16 chassis, locate the power receptacle where the power supplies
have been installed.
2. Lift the cord-retainer and connect a Brocade-supplied AC power cord to the power supply.
1 Power supply 2 Release latch
1
2