Filter
Top Products
Page 112 MNNCEKRKB1_0439
6.21 Videotec Receivers with Macro protocol
6.21.1 Note
The Macro protocol extends over a range of products with widely different specifications.
Consult the receiver manual for information to find out which functions are available.
6.21.2 Reference m aterial and documents
Videotec DTRX3 telemetry receiver
6.21.2.1 Receiver settings
The new generation of Videotec receivers allows the choice of two protocol types (Videotec and Macro).
The chapter refers only to the Macro protocol. Configure the receivers following the instructions given in the
respective manuals.
For all setup operations the keyboard must be enabled to perform the receiver setup (menu
).
Receiver ID-number must be set according to the respective installation manual.
Baudrate can be selected among the following values: 1200, 9600 (default), 19200, 38400 baud.
6.21.2.2 Keyboard settings
During Keyboard setup, submenu
must be suitably set:
Baudrate must be equal to the one selected for the dome.
6.21.3 Connection
6.21.3.1 Cable
The Videotec and Linxs receivers can be connected directly to the keyboard using the telephone cable supplied
(for testing and checks) or a telephone cable for distances of up to 1200 m, using the standard connection cable
described in see § 3.3 - Standard connection cable, page 12.
6.21.4 Setup
start setup
end of setup and reset receiver
6.21.5 Autopan
activate/deactivate autopan (toggle)
autopan on
autopan off