Filter
Top Products
Page 28 MNNCEKRKB1_0439
5.2.4.2 Requesting the views
Press a key from
to to request the corresponding view.
5.2.4.3 Erasing the customised views
Press keys
simultaneously.
The default settings for the views can be used to recall cameras 1 to 9 directly without changing the active
monitor and without making scans. The
recalls camera 10.
5.2.5 Receivers a ssociated with the cameras
To each camera is associated a telemetry receiver.
It is possible for one receiver to be present for each camera and this receiver is assigned permanently at the
system installation stage. When the camera-receiver association has been defined it should never be changed
unless there are changes to the system itself.
The installation procedure normally expects the assignment of a receiver number corresponding to that of the
video input (for example, camera number 10 is controlled by receiver number 10), but the assignment may be
more flexible.
Every time a camera has been requested and following this selection a new receiver number is requested, this
receiver number will be “remembered” by the keyboard. If requesting a different receiver number from the pre-
assigned number is not to be allowed, we advise disabling the setup menu option:
For example:
Camera 1 has been requested. The display
shows that the receiver currently associated
with this camera is number 1.
If the operator is authorised to do so, he can
assign another receiver number to the camera;
if not the display shows an error message.
Camera 2 has been requested, and the display
shows that it is currently associated with
receiver 2.
Following the new request for camera 1 the last
receiver associated with camera 1 is shown.