Filter
Top Products
Rev. 1.0, 07/01, page
vi
of
xxiv
5. When the E10T is used, address breaks can be set as available to the user, or for use by
the E10T. If address breaks are set as being used by the E10T, the address break
control registers must not be accessed.
6. When the E10T is used, NMI is an input/output pin (open-drain in output mode), P85
and P87 are input pins, and P86 is an output pin.
H8/3694 Series manuals:
Manual Title ADE No.
H8/3694 Series Hardware Manual This manual
H8/300H Series Programming Manual ADE-602-053
User's manuals for development tools:
Manual Title ADE No.
C/C++ Compiler, Assembler, Optimized Linkage Editor User's Manual ADE-702-246
Simulator/Debugger User's Manual (Windows) ADE-702-037
Simulator/Debugger User's Manual (UNIX) ADE-702-085
Hitachi Debugging Interface User's Manual ADE-702-212
Hitachi Embedded Workshop User's Manual ADE-702-201
H8S, H8/300 Series Hitachi Embedded Workshop, Hitachi Debugging
Interface User’s Manual
ADE-702-231
Application Notes:
Manual Title ADE No.
H8/300H Series CPU Guide ADE-502-033
H8/300H Series On-Chip I/O Ports Guide ADE-502-036
H8/300H Technical Q & A ADE-502-038
H8S, H8/300 Series C/C++ Compiler Guide ADE-502-044