Konica Minolta VIVID 9i Universal Remote User Manual


 
194
Chapter
2
Build
Menu
9i
910
900
700
300
n Extracting a Face
Extract a face from the selected points as explained below.
Operating Procedure
The following steps must be carried out in Build – Move – To X-Y-Z mode.
Parameters for [Select Face Attribute] Dialog Box
XY-Plane
Generates a XY plane based on the selected points.
YZ-Plane
Generates a YZ plane based on the selected points.
ZX-Plane
Generates a ZX plane based on the selected points.
1
Select the desired points.
M
emo
Select the points using the Select and View menu com-
mands.
After operation, please cancel the Select or View menu
command.
2
Click the right mouse button.
The [Select Face Attribute] dialog box will ap-
pear.
3
Select the desired face attribute from
the pull-down menu.
When the selected attribute of the face is “XY-
Plane”, Z-Axis is made in agreement with the
face normal.
But the direction of the axis is calculated by
the algorithm. If the direction is not suitable,
click the [Reverse] button in [Conrmation(for
coordinate)] dialog box to reverse the axis
direction.
4
Click the [OK] button.
The generated face will be displayed, and the
[Conrmation] dialog box will appear.
5
Click the [OK] button.
Proceed to the extraction procedure for the
next element (point or line).
Build – Move – To X-Y-Z