Filter
Top Products
58
Chapter
2
File
Menu
910
File – Import – Digitizer – Step Scan (When VIVID 910 is Selected)
Performing Step Scan with the VIVID 910
This command is used to cause the VIVID 910 (VI-910) to make multiple shots of the object by controlling
the rotary stage remotely from this software. Registration of multiple scan data can be performed using the Calibra-
tion Chart for extract center of rotation.
Warning
Never stare into the laser emitting window.
Do not place a lens, mirror or optical element in the passage of the laser beam. Doing so may converge the
laser beam, resulting in damage to your eyes, burns or re. To prevent the above accidents, make sure that a
wall or similar which can block the laser beam is located behind the object.
n When Using Only the Rotating Stage
Operating Procedure
1
From the [File] menu, select [Import],
[Digitizer] and then [Step Scan].
The [File-Import-Digitizer-Step Scan] dialog
box will appear.
M
emo
• The calibration chart is an accessory of the rotating
stage set.
• Before performing the procedure below, make sure that
the digitizer you are going to use is selected by the File
– Select Digitizer command.
Ref.
For details, refer to parameters (P.144) for [File-
Import-Digitizer-Step Scan-Option] dialog box.
• The monochrome monitor image captured by the
VIVID 910 will appear in the Work window area
of the dialog box.
• If the Model folder contains the Chart data that is
considered to be appropriate, it will be imported
automatically.