Filter
Top Products
13
Press the Display button
8
once; the DVR
will display the following sample message plus
the default display. Press the Display button
8
again; the unit will not display any OSD
message. Press the button one more time to
go back to the default display.
Total capacity of installed hard disk: 59 GB.
(12.4 HR): Total 12.4 hour recording time available.
( ): Timer record activated.
(
): Alarm record activated.
(
): motion detection activated.
(QUALITY: BEST): Record quality setting: BEST.
(NTSC ): NTSC system.
(RATE: 6 HR): Setting of Record time mode: 6 hours.
(20 F/S): Record speed setting: 20 fields/sec.
(MUX: OFF): Only connected to a single camera.
( ): Audio function activated.
(
): Indicates which HDD is activated.
( 9K ): The image file size
.
( HD ): Hard-disk compartment.(HD2 IS FOR
REMOVABLE MODEL ONLY)
(CD):CD-RW Compartment. (FOR CD-RW MODEL
ONLY)
( SIZE 20G): The capacity of the installed hard disk.
( REC ): Percentage of system Recording.
( PLAY ): Percentage of system Playback.
( IP : 192 . 168 . 1 . 90 ): Network IP Address
192.168.1.90
(
): External signal.
( x ): Cannot operate now.
2.4 Updating System Software
Please take the following steps to safely update it.
1. Inserting your SD card into your SD card
reader.
2. Plug your card reader's USB connector into
your PC.
3. Save the firmware ( the multi.bin file ) into the
SD card.
4. After you have checked that the saving is
complete, take the SD card out of the card
reader.
5. Turn off the DVR.
6. Insert the SD card into the built-in SD slot of
the unit.
7. Hold down the the Up
12
and Down
13
buttons simultaneously, and then turn on the
DVR.
8. Keep holding down the buttons until the DVR
sounds a tone and display the message
“ XXXXXX BYTES READ” Now the DVR is
updating the system software, which will take
approximately 90 seconds to process.
9. Restart the unit when the device sounds a tone
twice and displays the message “PLEASE
RESTART” The process is complete.
(If you have already followed the procedure
1~9. the unit, however, not being able to power
on. Please first check if the SD card you are
using is functioning and the file is intact. And
then start procedures 1 ~ 9 all over again.)
10. Verify the version of the system software from
the “MAIN MENU -> SYSTEM -> VERSION” by
push down Setup button. (Please refer to
section 4.6 VERSION.)
!
Caution:
1. Before carrying out the updating procedures, please
ensure the SD card is working and the file of system
software is intact.
2. Don’t interrupt the process while the unit is updating
itself, as this will cause the unit to crash.
1+2 :59G 12.4 HR
QUALITY : BEST
NTSC
RATE :6HR
MUX :ON
20 F/S
9K
HD SIZE REC PLAY
1 20G 10.0% 0.1%
2 39G 0.0% 0.0%
(For removable HDD model only)
CD 133M 80.0% (For CD-RW model only)
IP : 192.168.1.90
14-04-2005 09:46:53
13 12