Filter
Top Products
42
RECORD
ALARM / MOTION
CLOCK/ TIMER
COMMUNICATION
DISK
SYSTEM
MAIN MENU
GOTO COMM PAGE
RJ-45 PIN configuration for LAN Hub
5.1.2 Configure Your DVR Network
Settings
Upon network hardware connection, you
need to activate the network function and
configure the proper network settings of the
DVR.
5.1.2.1 Enable DVR Network Function
z Press the Setup button to enter the
OSD MAIN MENU. Please use the“<”
11
and “>”
14
buttons to highlight
COMMUNICATION; then press the
Enter button to enter the COMM
SETTING page.
z Use the “
^”
12
“v”
13
buttons to
highlight NET ENABLE; select ON. Then
press the Enter button to proceed.
5.1.2.2 Enable DHCP Function
Use the “^”
12
and “v”
13
buttons to
highlight NET DHCP; select ON.
NOTE: This function can only work if the LAN
which the unit is connected to has a DHCP
server. If the DHCP server is working, the DVR
will obtain an IP address automatically from
the DHCP server. In that case please skip
section 5.1.2.3 (Set IP address) and follow
section 5.1.3 (TCP/IP Communication
Software).
5.1.2.3 Set IP Address
PIN NO.
PIN
Assignment
1.
TX +
2.
TX -
3.
RX +
4.
Not Connected
5.
Not Connected
6.
RX -
7.
Not Connected
8.
Not Connected
1 2 3 4 5 6 7 8
RJ-45 socke
t
NETWORK ( continued )
COMM SETTING
COMM ID :01
RS232 :ON
RS485 :ON
BAUD :2400
NET ENABLE :OFF
NET DHCP :OFF
NET IP :SET
NET ACCOUNT :SET
FTP SETTING
MAIN PAGE
RECORD
ALARM / MOTION
CLOCK/ TIMER
COMMUNICATION
DISK
SYSTEM
MAIN MENU
GOTO COMM PAGE
RECORD
ALARM / MOTION
CLOCK/ TIMER
COMMUNICATION
DISK
SYSTEM
MAIN MENU
GOTO COMM PAGE
COMM SETTING
COMM ID :01
RS232 :ON
RS485 :ON
BAUD :2400
NET ENABLE :OFF
NET DHCP :OFF
NET IP :SET
NET ACCOUNT :SET
FTP SETTING
MAIN PAGE