Filter
Top Products
29
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••Setup wizard
ENGLISH
step6
-1
. Set the HDD configuration.
Normal: Does not set the partition.
Partition: Sets an independent partition for alarm
recording within the total HDD memory. When
selecting “Partition,” set the partition capacity.
• Select “Next” when selecting “Normal.”
• Select “Setting” to set the partition capacity when
selecting “Partition.”
step6
-2
. (When selecting “Partition”)
Set the desired partition capacity.
Normal Recording Area: The area for normal
recording.
Alarm Recording Area: The area for alarm
recording.
Long Pre-Alarm Area: The area for long pre-alarm
recording.
• Set the partition capacity for each area in 5 %
unit.
• When the setting is completed, return to the
screen of step 6-1 and then select “Next.”
step7. Select whether or not to make the recording settings.
• To set the recording settings, select “Next.”
• Select “Quit” to exit the setup wizard without
setting the recording settings. The power of the
unit turns on.
• In the recording setting screens, you can return to
the previous screen by pressing the “Return” button.
step8. (When selecting “Next”)
The unit automatically checks the condition of the
picture supplied from the camera and then sets the
camera number to be recorded by selecting
“Execute.”
• Select “Next” when the setting is completed.
step9. Set the recording time.
• Set the recording cycle and the recording hour
per day.
• Select “Execute” when the setting is completed.
step10. The maximum recording rate and the picture grade
for the camera numbers detected on step 8 are
automatically set.
• Field recording is selected.
• The same settings are applied for normal and
alarm recordings.
• Select “View” to confirm the settings you have
set. Select “Next” when the setting is completed.
step11. Select “Finish” to exit setup wizard.
• The unit boots-up.