Mitsubishi Electronics DX-TL5000E DVR User Manual


 
64
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
System (continued) Setup Menu
Alarm Display Setting
This item is used to display the picture input with alarm
signal in the single screen display or split screen display
which has been pre-set. When another alarm signal is in-
put during alarm recording, the picture with the latest alarm
signal appears in the single screen display or split screen
display. The screen returns to the previous display when
the alarm recording is completed.
The alarm display setting is available for each output A or
B. Select the desired output for alarm display. You cannot
use alarm display on both output A and B at the same time.
Setup Menu
Alarm Display Setting
4
5
Multiplexer Setting
System
4
step1. Select output A or output B.
step2. Select the desired single screen display or split
screen display which is set in the <Multiplexer
Setting> to be displayed when the alarm signal is
input for each sensor connected.
Covert Camera Setting
This item is used to set the picture of the specified camera
number not to be displayed regardless of the presence of
video signals.
6
9
1
2
3
10
11
13
14
15
16
12
4
8
57
When the picture is interrupted due to the camera
trouble, etc. while the <Covert Camera Setting> is
set to Off, the warning message does not appear
on the screen, however, if Warning is set for Buzzer
setting, the buzzer sounds. The unit registers this error
in the <System Log List> and outputs the CALL OUT
signal.
When setting <Covert Camera Setting> to Off for a
camera set for recording operation, recording is
performed without displaying the picture on the
screen.
When <Covert Camera Setting> is set to Off, the
playback picture is not displayed and the screen turns
blue for that camera number. To display the playback
picture, set it to On.
When <Covert Camera Setting> is set to Off, the
operational mode display and alarm display setting
do not function.
Setup Menu
Covert Camera Setting
5
5
Multiplexer Setting
System
4
step1. Set the covert camera setting for each camera
number.
On: Displays the picture supplied from the camera.
Off: Does not display the picture supplied from the
camera and the screen of that camera turns blue.