Mitsubishi Electronics DX-TL5000E DVR User Manual


 
44
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Information/Audio User Menu
CH4: Outputs the audio from the AUDIO IN 4
terminal during displaying the picture from the
camera. Outputs the recorded audio of AUDIO
IN 4 terminal during playback.
The audio channel which is output for the first time
after switching a picture from the camera is set with
<Audio Setting> (Setup Menu
System Audio
Setting). (
see page 66)
When switching the multiplexer (for example, Split 4
sequential Split 9 sequential, Single screen
sequential
Split 4 sequential, Camera number
1
Camera number 5), the setting is reset to the setting
set in the <Audio Setting>. When switching the picture
supplied from the camera to the playback picture, or
from playback picture to the picture supplied from the
camera, the setting is also reset to the setting set in
the <Audio Setting>. To fix the audio output, use the
<Audio Setting> (Setup Menu System Audio
Setting).
The audio is output in sync with OUTPUT A. During
playback, the recorded audio is output. During
displaying the picture from the camera, the audio from
camera is output.
Information
This item is used to check the recorded range of the main,
copy A, or copy B device.
Main Storage Memory Information
Copy A Drive Information
Copy B Drive Information
User Menu
Information
step
1
3
1
2
3
step1. Select the device to be checked from <Main Storage
Memory Information>, <Copy A Drive Information>,
and <Copy B Drive Information>.
Update Information: Updates the recording
information.
•“Partition (Alarm) Information appears when Alarm
Recording Area (System Menu Memory Data
Management Setting for Main Memory Change
Partition Setting) is set to other than 0 %.
•“Partition (LPA) Information appears when Long Pre-
Alarm Area (System Menu
Memory Data
Management Setting for Main Memory Change
Partition Setting) is set to other than 0 %.
Audio
This item is used to switch the audio channel among 1 to 4
during playback or displaying the picture supplied from the
camera.
This function is available only when the optional audio
interface board DX-SC5 is attached to this unit.
User Menu
Multiplexer Setting
Audio
4
1
step1. Select the desired audio channel.
CH1: Outputs the audio from the AUDIO IN 1
terminal during displaying the picture from the
camera. Outputs the recorded audio of AUDIO
IN 1 terminal during playback.
CH2: Outputs the audio from the AUDIO IN 2
terminal during displaying the picture from the
camera. Outputs the recorded audio of AUDIO
IN 2 terminal during playback.
CH3: Outputs the audio from the AUDIO IN 3
terminal during displaying the picture from the
camera. Outputs the recorded audio of AUDIO
IN 3 terminal during playback.