Filter
Top Products
90
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Basic operations (continued)
Basic playback
This function is used to playback the recorded data. This
unit allows recorded data to be played back using various
methods. The basic playback described here is the most
common method for playback.
step1. Press the PLAY button inside of the front door.
• Playback starts.
• After turning the power on, the oldest recorded
data is played back first. Otherwise, playback
resumes at the stopped position of the previous
playback.
STOP
PAUSE
REV. PLAY
PLAY
JUMP TO END SPEED
• When the “Playback Device Repeat Setting” (System
Menu Memory Recording Data Readout Setting)
is set to “Repeat Off,” playback stops when reaching
the physical end of the HDD or end point of the recorded
section. When the “Playback Device Repeat Setting”
is set to “Repeat On,” recorded data is played back
repeatedly ( see page 75).
(To change the playback device:)
step2
-1
. Select the playback device and playback area in the
<Select Source Device> (User Menu Search Select
Source Device).
Main: Plays back the recorded contents of the main
device.
Normal: Normal recording area
Alarm: Alarm recording area
LPA: Long pre-alarm recording area
Copy A: Plays back the recorded contents of the
copy A device.
Group1, 2, 3, 4, 5
Copy B: Plays back the recorded contents of the
copy B device.
Group1, 2, 3, 4
•“Alarm” appears when “Alarm Recording Area”
(System Menu Memory Data Management Setting
for Main Memory Change Partition Setting) is set to
other than “0 %.”
•“LPA” appears when “Long Pre-Alarm Area” (System
Menu
Memory Data Management Setting for Main
Memory Change Partition Setting) is set to other than
“0 %.”
step2
-2
. Press the PLAY button.
• Playback of the selected device starts.
• When pressing the PAUSE/JUMP TO END button
during the playback is stopped, the still frame playback
picture of the end point of the latest recording is
displayed.
step3. To pause playback, press the PAUSE button.
• To resume playback, press the PAUSE button
again or press the PLAY button.
step4. To stop playback, press the STOP button.
• When executing playback again, the playback
starts from the stopped position of the previous
playback.
• Pressing the OUTPUT A/B button on the front panel
switches the multiplexer output of the unit. When
OUTPUT A is selected, the light of the button turns
off. When OUTPUT B is selected, the button lights up
and the buttons related to playback function are
operated for the monitor screen connected to the
OUTPUT B connector. Pressing the OUTPUT A/B
button again switches the multiplexer output to
OUTPUT A.
• The playback of each camera may not be executed
at a constant speed depending on the recorded
condition.
• During the split screen display, the playback may be
executed at the pps which is lower than the one used
for recording.
• When playing back on both OUTPUT A and B, the
playback speed may become slower.