Mitsubishi Electronics WD-57833 Flat Panel Television User Manual


 
2. TV Setup 13
Change the Menu Language
Choose to display on-screen menus in either English or 
Spanish (Español).
Select a menu language in the Setup menu.
1.  With the Setup menu displayed, press    to high-
light the Language icon.
2.  Press   to highlight either English or Spanish.
3.  Press 
MENU
 to return the highlight to the top row of 
icons.
Memorize Channels
For ANT 1/MAIN and ANT 2/AUX
To start channel memorization
1.  With the Setup menu displayed, press   to high-
light the Scan icon.
2.  Press   to highlight an input selection based on 
your connections:
Input Condition
Ant 1 Air
Ant 2 Air
When connected to an indoor or 
outdoor antenna
Ant 1 Cable
Ant 2 Cable
When connected to direct cable (no 
cable box)
3.  Press   to highlight the on-screen START button.
4.  Press 
ENTER
 to start automatic channel memoriza-
tion.
To stop channel memorization before
completion, press
CANCEL
.
Start channel memorization from the Setup menu.
Additional TV Setup Using the Setup Menu
See chapter 5, “TV Menu Settings,” to:
•  Edit channel options
•  Set the TV clock
•  Set the TV Timer
•  Select an Energy Mode to manage power use while 
the TV is off.
•  Select a lamp brightness mode
Initial TV Setup, continued
5.  When memorization is complete you can:
•  Press 
MENU
once to return to the top row of icons.
•  Press 
MENU
again to return to the Main menu.
•  Press 
EXIT
 to watch TV.
After channels have been memorized:
•  To tune to memorized channels, press 
CH
 / 
while watching TV on the 
ANT 1
 or 
ANT 2
 inputs.
•  Use the Setup > Edit menu for additional channel 
options, such as adding or deleting channels from 
memory, naming channels, and saving favorite 
channels in custom memory banks.
Setting Up TV Inputs
When You First Connect a Device
This TV’s Easy Connect™ Auto Input Sensing feature 
detects most connections automatically.  When you 
first connect a device, the TV will:
a.  detect the connected device
b.  prompt you to identify the device type
c.  prompt you to perform NetCommand set-up for 
the device, if available
d.  repeat these steps for any additional newly 
detected devices
The tables below state which connections trigger Auto 
Input Sensing.
Auto Detection Active No Auto Detection
INPUT
video jacks
ANT 1
 and 
ANT 2
COMPONENT
 video jacks
HDMI
*
DIGITAL AUDIO OUT
AVR AUDIO OUTPUT
 (analog)
USB
(USB photo port on front)
*
If the device is powered off when connected, detec-
tion occurs when the device is next powered on.
Note: For connection and setup of a personal com-
puter, see the information later in this chapter.