Mitsubishi Electronics WD-57833 Flat Panel Television User Manual


 
74 Appendices
IMPORTANT
You may need to reprogram the remote
control after changing the batteries.
Programming the Remote Control
1.  Move the slide switch at the top of the remote to 
the position for the product you want to control.  
Refer to the table below.  Only one of each device 
type can be controlled in each slide-switch position.
Switch Position Affected Device
CABLE/SAT
Cable Box
DTV Receiver
Satellite Receiver
VCR
VCR
DVR
Laser Disc Player
DVD Player/Recorder
DVD
DVD Player/Recorder
DVR
Laser Disc Player
VCR
AUDIO
A/V Receiver
Audio Amplifier
CD Player
2.  Press and hold 
POWER
 on the remote control for 
several seconds until the button blinks twice and 
goes off.
3.  Release the 
POWER
 button.
4.  Enter the first five-digit code listed for your equip-
ment.
•  The 
POWER
 button blinks twice when you start to 
enter the code and then once for each addi-
tional keypress.
•  The 
POWER
 button blinks twice when you finish 
entering a valid code.
•  Move the slide switch to another position if you 
need to start over or wish to exit programming 
mode.
5.  Point the remote control at the equipment and 
press 
POWER
.  If the product has no power on/off 
function, press a different key, such as  (
PLAY
),
(
STOP
),
VOL
, or
MUTE.
•  If the equipment responds, the remote control 
is properly programmed to operate the equip-
ment.
•  If the equipment does not respond, repeat 
steps 2–4 with the next five-digit code listed for 
your equipment.
6.  Once you have found the correct code, write it in 
the space below for future reference.
Switch Position
Device Type Code
CABLE/SAT
VCR
DVD
AUDIO
Code Verification
To determine the code programmed for any position of 
the slide switch:
1.  Move the slide switch to the position you wish to 
verify.
2.  Press and hold 
POWER
 on the remote control for 
several seconds until the button blinks twice and 
goes off.
3.  Press keys 
9 9 0
4.  Press 
1
 and count the blinks of the power button.  
Write down the number of blinks as the first digit of 
the code.
5.  Repeat step 4 for the second, third, fourth, and fifth 
digits of the code.
Appendix D: Programming the Remote Control, continued
Audio Lock: Universal A/V Receiver Control
With Audio Lock active, the remote control operates 
the volume and mute functions of the A/V receiver in all 
positions of the slide switch.  Activate Audio Lock if you 
normally use an A/V receiver with your TV and other 
A/V equipment.
1.  Program the 
AUDIO
 position for your A/V receiver as 
described earlier in this section.
2.  Move the slide switch to the 
AUDIO
 position.
3.  Press and hold 
POWER
 on the remote control for 
several seconds until the button blinks twice and 
goes off.
4.  Press keys 
9 9 3 ENTER
The 
POWER
 button will blink twice to indicate Audio 
Lock is active.
To Reset the Remote Control to Operate Volume
and Mute for the TV Speakers
1.  Press and hold 
POWER
 for several seconds until the 
key blinks twice and goes off.
2.  Press keys 
9 9 3 VOL
.
The 
POWER
 key will blink four times to indicate Audio 
Lock has cleared.