Mitsubishi Electronics WD-57833 Flat Panel Television User Manual


 
60 6. NetCommand
Perform this setup to:
•  Operate the A/V receiver’s power and volume 
functions with the TV’s remote control.
•  Enable the A/V receiver to switch automatically 
to the correct audio input when you select a 
device in the TV’s Input Selection menu.
To set up control of an A/V receiver you need:
•  The remote controls for both the TV and the 
A/V receiver.
•  The IR emitter cable supplied with the TV.
Note: To set up control of other device types, see 
“Initial NetCommand Setup for Most Devices” 
earlier in this chapter.
Perform this setup using the Inputs > AVR screen, 
shown below.
1
3
4
2
AVR screen overview
1. Power and volume 
commands the TV can send to the
A/V receiver when “learned”
2.
A check under
Learn/Name
means the TV has
“learned” the command to switch the A/V receiver to the
input.
3.
Input1 through Input4 are temporary placeholder names
for A/V receiver inputs. Use this screen to assign mean-
ingful names , e.g., the name of the A/V receiver input.
4. Match up devices connected to the TV inputs with
audio inputs on the A/V receiver.
3.  Set the 
TV’s remote control slide switch to the 
TV
position.
4.  Open the AVR screen in one of two ways:
•  If using the 
Auto Output Sensing screen for 
the A/V receiver, highlight the Learn icon and 
press 
ENTER
 to open the AVR screen.
•  If performing NetCommand setup at any time 
after the A/V receiver has been recognized 
through Auto Input Sensing:
Press 
MENU
, highlight Inputs, and highlight AVR
to open the AVR screen.
5.  The first function highlighted in the AVR screen is 
always Power On.  Aim the TV’s remote control at 
the TV and press 
ENTER
 to begin learning for Power
On.
A/V Receiver (AVR)
screen. Perform
NetCommand IR
“learning” for A/V
receiver power and
volume keys.
6.  When the 
Power On text starts flashing, aim the 
A/V receiver’s remote control at the TV and press 
and hold the 
POWER
 or 
POWER ON
 key until a check mark 
appears next to Power On.
•  If the text stops flashing before the check mark 
appears, repeat this step.
•  To remove the key from NetCommand control, 
press the 
CANCEL
 key while the key name is 
highlighted.
By completing “learning” for the power key,
NetCommand now operates the power function for
the A/V receiver.
Point the TV’s remote control at the TV to control
the A/V receiver.
7.  Press the   key on the TV’s remote control to high-
light other keys in the list.  Repeat steps 5 and 6 for 
each additional function you wish to control through 
NetCommand.
8.  If the A/V receiver has a separate 
POWER OFF
 key, 
press   on the TV’s remote to highlight Power Off.  
Repeat steps 5 and 6 to “learn” the 
POWER OFF
 key.
9.  When finished “learning” the power and volume 
keys, either press 
EXIT
 to watch TV or proceed to the 
next section to continue NetCommand setup of the 
A/V receiver.
Setup to Control the A/V Receiver’s Power
and Volume Functions
1.  Connect your A/V receiver to the TV and any addi-
tional devices.   See chapter 3, “TV Connections,” 
for suggestions.
2.  Connect the IR emitter cable to the TV and position 
the IR emitter where it can send signals to the A/V 
receiver.
Setting Up NetCommand Control of an A/V Receiver