Mitsubishi Electronics WD-57833 Flat Panel Television User Manual


 
Appendices 87
IEEE 1394 Devices
Symptom Remarks
1. Excessive digital artifacts appear when 
viewing an IEEE 1394 device.
•  The IEEE 1394 cable is too long; 15 feet between devices is 
the maximum.
•  There may be a slow device in the middle of the IEEE 1394 
network.  Move the slow devices to the end so that connec-
tions for faster devices do not pass through them.
2. D-VHS recordings for digital cable have 
drop-outs (loss of picture or sound), or no 
playback.
Digital cable signals on IEEE 1394 can exceed the data rate stan-
dards supported by DVCR.
3. The IEEE 1394 Device is no longer listed in 
the Input Selection menu.
•  The IEEE 1394 plug is disconnected or loose.
•  The IEEE 1394 device has not been powered on.  Turn on.
•  The device has not been discovered.
•  The device is not an audio/video device
4. MENU button does not display a menu. •  The IEEE 1394 device does not provide a menu.
•  The TV cannot support the IEEE 1394 menus from this 
device.
IEEE 1394 Recording
Symptom Remarks
1. Program to be recorded was correctly 
selected from ChannelView, but incorrect 
program was recorded.
•  The broadcaster supplied program information that was 
incorrect and/or was changed after a recording was added to 
the Record List.
•  TV Clock not set.
•  Daylight Savings Time option is incorrect.
2. Incomplete ChannelView program recorded.
Recording device may lack sufficient blank space to make a full 
recording. 
3. ChannelView program recording failed. •  Connection and compatibility issues with IEEE 1394 
(FireWire
®
) digital devices.  This may include too many 
Firewire devices in use at one time, or the recording device 
not understanding the record command.
•  Television lost power long enough to lose current clock time.
•  TV energy Mode was set to Low Power.  Change TV Energy 
mode to Fast Power On.
4. Cannot record to or from the IEEE 1394 
device, including dubbed recordings.
•  To initiate a recording to IEEE 1394 device, first switch the 
TV to the desired input (recordable inputs are ANT1, ANT2, 
INPUT 1–3).  Press the    (RECORD) key.  The Record > 
Schedule menu will display to allow setup of the recording.
•  The source device for the recording is not powered on.
•  When dubbing, the destination device for the recording is not 
powered on.
•  The program is copy protected.
•  The program has already been recorded once and the copy 
protection only allows one recording.
•  Unapproved source device for copy protected material.
•  The recording device cannot decode the copyright signal 
included in the signal source (try another device if available).
•  The playing device (for dubbing) does not support copy-
righted material.
•  Source for recording is copyrighted
•  Too many IEEE 1394 devices in network. Insufficient band-
width available.  Disconnect unused devices.
•  IEEE 1394 source device has higher communication speed (S 
400) than record device.  If possible, reverse devices, play in 
the slower device and record in the faster device.