Filter
Top Products
3 - 1 3 - 1
MELSOFT
3 INSTALLATION AND UNINSTALLATION
3. INSTALLATION AND UNINSTALLATION
This chapter explains how to install and uninstall the product.
3.1 Installation
3.1.1 Installing Procedure
Install GX Converter in the following procedure.
New installation
Install the product.
Register the name and company.
Register the product ID.
Refer to
Section 3.1.2 (1).
Updating
Refer to
Section 3.1.2 (3).
Refer to
Section 3.1.2 (3).
Refer to
Section 3.1.2 (1).
Boot the product.
Check whether the product has been
installed properly.
Complete
Complete
Install the product.
Register the name and company.
Register the product ID.
Register the product ID of the older
product.
Boot the product.
Check whether the product has been
installed properly.
Uninstall the older version.
Refer to the startup
manual of the older
version product.
POINT
If the DLL overwrite confirmation message appears during installation, choose
"Yes" to overwrite the DLLs.
If they are not overwritten, the product may not be run properly.
3