Onkyo L-MS30 DVD Player User Manual


 
26
Connecting the Power/Turning on the DVD receiver
Before connecting
Make sure that all the connections from pages 17 to 25 are
complete (the connection to the TV is required).
Turning on the DVD receiver may cause a momentary power
surge, which might interfere with other electrical equipment such
as computers. If this happens, use a wall outlet on a different
circuit.
The DR-L30 is shipped with the POWER in the ON position
(_ ON). When the power cord is plugged in for the first time, the
DR-L30 will automatically turn on.
1 Connect the power cord to a wall outlet.
2 Press POWER on the DVD receiver turn on the
DVD receiver.
3 The display on the DVD receiver’s front panel
light.
To put the DVD receiver in the standby mode, press
STANDBY/ON on the remote controller. Be sure to set the
volume to minimum before putting the DVD receiver in the
standby mode for the next use to avoid sudden loud sound
reproduction.
While in the STANDBY mode, the DVD receiver can
receive signals from the remote controller.
Setting the STANDBY/ON button on the remote controller to
set the DVD receiver to standby does not turn off the power
completely.
Turning on the subwoofer (SKW-L30)
1 Connect the power cord to a wall outlet.
2 Press POWER to the ON position.
The indicator changes from red to green when the subwoofer
receives a signal.
POWER
STANDBY/ON
STANDBY indicator
To wall outlet
OUTPUT
LEVEL
LINE
INPUT
MIN
MAX
POWERED
SUBWOOFER
MODEL NO. SKW
-
L
30
POWER
ON OFF
POWER
To wall outlet
STANDBY/ON
indicator
EN00_L-MS30.book Page 26 Tuesday, September 2, 2003 4:19 PM