Filter
Top Products
63
Main unit
Symptoms Causes Remedies Pages
Playback does not start when
the
£/8 button is pressed.
• There is no disc in the DVD receiver.
• There are no signals recorded on the side of
the disc being played.
• Load a disc and press the
£/8 button.
• Turn the disc over and properly place it on the
disc tray.
36
36
Playback starts but no
image/sound is seen heard.
• The TV is not turned on.
• The connection cords are not properly
connected.
• Turn on the TV.
• Properly reconnect the connection cords.
–
17–23
The picture is disrupted
when the image is fast
forwarded or fast reversed.
• The picture is slightly disrupted during fast
forward and fast reverse operations.
• This is not a malfunction. –
No sound is heard. • The audio output cords are not properly
connected.
• The player is in a special playback mode.
• Properly connect the audio cords.
•Press the
£/8 button to resume normal
playback mode.
20
–
The picture does not look
good or the picture/sound
quality is poor.
• A nearby device is generating noise.
• The disc is dirty.
• The disc is damaged.
• There is condensation on the optical lens.
• Separate this unit as far as possible from the
device you think is generating the noise.
• Refer to the “Cleaning Discs” section and
wipe dirt from the disc.
• Use a new disc.
• Refer to the “Notes on Moisture
Condensation” section and evaporate the
condensation.
–
11
–
3
It takes a while for the disc
to start playing.
• Time is required for the unit to detect the disc
type and size and for the rotation of the motor
to stabilize. This is not a malfunction.
• Approximately 10 to 20 seconds are required
for a disc to start playing, although the time
differs depending on the disc.
–
The tray opens
automatically.
• The disc is not placed horizontally. • Properly place the disc on the tray. 36
The top and bottom of the
screen cannot be seen, or the
screen becomes black-and-
white.
• The video format of the disc being played
does not match that of the connected TV
monitor.
• Refer to the “To set the TV system” section,
and use a disc with the appropriate video
format for your TV or a TV with the
appropriate video format for the disc.
27, 29
The subtitle is not displayed. • The DVD disc being played does not contain
the recording of subtitles.
• The subtitle mode is set to off.
• The subtitle cannot be displayed when the
DVD disc being played does not contain the
recording of subtitles.
• Press the SUBTITLE button to switch on the
subtitle mode.
–
50
The voice (or subtitle)
language cannot be changed.
• The DVD disc being played does not contain
the recording of more than one audio (or
subtitle) language.
• The voice (or subtitle) language cannot be
changed when the DVD disc being played
does not contain the recording of more than
one voice (or subtitle) language.
–
The viewing angle cannot be
changed.
• The DVD disc being played does not contain
the recording of more than one angle.
• You are attempting to switch the angle in a
DVD section where more than one angle is not
recorded.
• The viewing angle cannot be changed when
the DVD disc being played does not contain
the recording of more than one angle.
• More than one viewing angle may be recorded
only in limited sections in a disc.
–
–
Playback will not start even
after a title is selected.
• A viewing restriction (PARENTAL) has been
set for the disc.
• Check the viewing restriction level
(PARENTAL) setting.
31
EN00_L-MS30.book Page 63 Tuesday, September 2, 2003 4:19 PM