Filter
Top Products
27
Customizing Function Settings
x
1 Set the POWER on the main unit to the ON
position.
After the power is switched ON, there is a delay of about
3 seconds before the display is lit.
2 Set TV Format according to the connected TV
type.
While no disc is inserted, hold the SURROUND button on the
main unit depressed and keep pressing the SUBTITLE button
on the remote control. Each time these buttons are being held
down, the setting changes as follows.
→ MULTI (NTSC/PAL switchable)
NTSC
PAL
When you insert a DVD Video, Video CD, or audio CD, the various
functions of the DVD receiver will be set (reset) according to the
SETUP MENU.
You can customize this setting menu according to your preference.
1 Press MENU during stop mode.
The SETUP MENU appears.
2 Press 5/a to select a category, then press
ENTER.
Remove the disc to customize the PREFERENCES settings.
To set the TV system
ENTER
MENU
2
/
3
/
5
/
a
SUBTITLE
Main unit Remote controller
Setting Steps
EN00_L-MS30.book Page 27 Tuesday, September 2, 2003 4:19 PM