Filter
Top Products
64
Troubleshooting
Remote controller
Others
The parental level cannot be
changed.
• You have forgotten the password. • Set the initial setup to the factory setup with
the following procedure.
1 While in stop mode, press and hold both
SURROUND on the main unit and TOP
MENU on the remote contoller for 2 seconds
or longer.
2 Press STANDBY/ON to set this unit in
standby mode.
OR
1 Press the MENU button on the remote
controller to enter SETUP MENU.
2 Select the PREFERENCE, then press the
ENTER button.
3 Select DEFAULTS, press the 3 button to
select RESET.
4 Press the numeric keys as shown below.
Press 1, 3, 9, 7, then press the ENTER
button.
5 Press STANDBY/ON to set this unit in
standby mode.
The password set at the time of shipping from
the factory is “0000”.
31
The voice or subtitle
language selected in the
initial setting is not played.
• The DVD disc being played does not contain
the recording of the selected voice or subtitle
language.
• The initial playback language is specified by
the DVD disc.
• The DVD specifications provide for selection
at the menu screen.
• Use a DVD disc containing the recording of
the selected voice or subtitle language.
• Press SUBTITLE or the AUDIO button on the
remote controller and select the language.
• Select at the menu screen of the disc.
–
50
–
Menu screen messages are
not shown in the desired
language.
• The menu language function is not set to
desired language.
• Select disc menu language. 31
A VCD cannot be played
using menus.
• The VCD disc being played is not compatible
with PBC.
• Menu playback is available only with VCD
discs recorded with PBC.
–
The STANDBY indicator
flashes red on the main unit.
• The speaker connection is abnormal. • Check the speaker connection.
• Check the speaker connection. If this does not
help, contact your dealer for service.
21
–
Symptoms Causes Remedies Pages
Symptoms Causes Remedies Pages
Remote control operation is
not possible.
• Batteries are exhausted.
• The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
• Replace with new batteries.
• Operate the unit inside the remote controllable
range.
9
9
Symptoms Causes Remedies Pages
The inhibition icon is
displayed and remote control
is not possible.
• Playback is restricted intentionally by the
software producer.
• The operation is inhibited. Please try another
operation.
–
EN00_L-MS30.book Page 64 Tuesday, September 2, 2003 4:19 PM