Open as PDF
Chapter 1: Connections & Setup
Chapter 1 7
1. Connect your VCR to the TV/DVD.
A. Connect the audio (white and red) cables to the AV1 or AV2 AUDIO In L and R jacks on the right
side of the TV/DVD (when you’re facing it) and to the Audio Output jacks on the VCR (sometimes
labeled L and R). Then connect the video cable (yellow) to the AV1 or AV2 VIDEO In jack on the TV/
DVD and to the Video Output jack on the VCR.
You can also use this connection for another component, such as a camcorder or video game system.
B. Connect a coaxial cable to the ANT. jack on the TV/DVD and to the RF Output jack on the VCR
(sometimes labeled OUT TO TV). Use the supplied “L”-adapter to make this connection easier.
Connect the coaxial cable from your VCR to the “L”-adapter, then push the “L”-adapter onto the ANT.
jack on the TV/DVD.
2. Make sure cable or antenna is connected to your VCR.
Connect the coaxial cable from your cable outlet or antenna to the antenna input on the VCR (sometimes
labeled In From Antenna).
1628714C_1_C&S 8/27/04, 10:00 AM7