Filter
Top Products
39
Testing the System
adjust the Azimuth
1. If necessary, loosen the nuts on the support sleeve so that the
LNB support arm can rotate left and right.
2. Locate the piece of tape at the top of the mast. This tape is
marked with evenly spaced “tick” marks.
3. Carefully rotate the dish one tick mark to the right.
4. Pause to listen for five (5) seconds.
5. If you don’t hear the continuous tone from the signal meter,
rotate the dish back to the original azimuth position, then
rotate the dish one tick mark to the left. Pause to listen for
five seconds.
6. Continue rotating the dish further right and left one tick
mark at a time. Make sure to pause for five seconds before
changing the dish position.
Line edge of bracket
up with tick marks
Line up edge of
bracket with tick
marks
2
ROTATE RIGHT
One tick mark
Support
HANDS OFF
ROTATE LEFT
One tick mark
3-6