Filter
Top Products
46
Mounting the Mast
5. Remove the mounting foot and drill two 1/8" holes in
the two center hole locations and four 3/16" holes in the
four outside corner locations.
6. Use a 7/16" wrench to loosen the nuts on the mounting
foot so that you can rotate the mast to access both of the
center mounting holes.
7. Hold the mounting foot over the holes so that the top
part of the mast will rotate and point straight up.
8. Install two 5/16" x 3" lag screws into the two center
holes on the mounting foot. Securely tighten the screws.
9. Put washers on the 5/16" x 2" lag screws, insert the
screws into the four outside holes and securely tighten
them.
10. Turn to Final Approach on page 63 for instructions on
leveling the mast.
7
IMPORTANT
Do not mount the DSS
®
dish on any
type of aluminum or vinyl siding.
Do not mount the dish on any type
of composite paneling, such as fiber
board, particleboard, or strand board.
No
Yes
Yes