Filter
Top Products
61
Mounting the Mast
7. Fill all six holes with a small amount of roof sealant.
8. Use a 7/16" wrench to loosen the nuts on the mounting foot
so you can rotate the mast to access both of the center
mounting holes.
9. Hold the mounting foot over the holes so the top part of the
mast will rotate and point straight up.
10. Use two 5/16" x 3" lag screws in each of the centerline holes
to attach the mounting foot to the roof. Secure the four
outside corner holes with four 1/4" x 2" lag screws. Securely
tighten all six screws.
11. Seal the mounting foot with roof sealant. When applying
the sealant, make sure you seal the areas shown.
12. Go to “Final Approach” on page 63.
Yes
No
8
Sealant
11