Filter
Top Products
44
Mounting the Mast
Mounting On Wall Studs or
Solid Wood
Materials Needed to Mount the Mast on Wall Studs
or Solid Wood:
(2) 5/16" x 3" lag screws
(4) 5/16" x 2" lag screws
(4) 5/16" washers
Tools Needed to Mount the Mast on Wall Studs
or Solid Wood:
electric drill with 1/8" and 3/16" wood bits
bubble level
1/2" wrench
3/8" wrench
7/16" wrench
pencil
Important Considerations:
• Do NOT mount the dish where someone might use it as a
handrail.
• Make sure the wooden surface is structurally sound
• Do NOT mount the dish on any type of composite paneling,
such as fiber board, particle board, or strand board.
• Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
2
1
/
4
x 3" lag screws
4
5
/
16
x 2" lag screws
4
5
/
16
" washers
Two (2) 5/16" x 3" lag screws
Four (4) 5/16" x 2" lag screws
Four (4) 5/16" washers
Hint
To locate a stud underneath panel
siding, locate the nails securing the
panel to the wall. The nails usually
align with the center of the stud and
provide an easy guide.
DANGER! AVOID Power Lines!
When following these instructions, take extreme care to avoid
contact with overhead power lines, electric lights, and power
circuits. Contact with power lines, electric lights, or power
circuits may be fatal. It is recommended that the dish be
located more than 20 feet from overhead power lines.