Filter
Top Products
66
Final Approach
Final Dish Assembly
1. Place the dish-LNB arm assembly on top of the mast.
2. Find the length of RG-6 coaxial cable that will extend from
the satellite dish to the cable’s point of entry into the house.
If the distance of the RG-6 coaxial cable is greater than 112
feet you may need to break up the lengths of cable and
connect them with a in-line amplifier to ensure a high signal
strength. The in-line amplifier must be attached at a
location inside the house.
3. Push the coaxial cable through the bottom of the mast and
out the top. Pull about 2 feet of cable out of the top. Loop
the cable and push it through the LNB support arm as shown.
4. Place some silicone grease on the LNB connector and connect
the end of the coaxial cable to the LNB.
1
CABLE
cable
3
4