Filter
Top Products
55
Mounting the Mast
b. Pull the ring so the metal channel rests flush behind the wall.
Hold the ring tight and slide the plastic cap along the straps
until the cap is flush with the wall.
c. Push the straps side-to-side to snap them off flush with the
wall.
d. Repeat for all four holes.
7. Use a 7/16" wrench to loosen the nuts on the mounting foot
so you can rotate the mast to access both of the center
mounting holes.
8. Hold the mounting foot over the holes so the top part of the
mast will rotate and point straight up.
9. Place washers on each of four #20, 1/4" x 3" machine screws
and attach the mounting foot to the wall. Securely tighten
the screws.
10. Go to “Final Approach” on page 63 for instructions on
leveling the mast.
Wall
Plastic cap
Ring
Metal
channel
6b
6c
No
Yes
8