Filter
Top Products
22_ connecting with other device
connecting with other device
If not using a Broadband Router
For setting <IP Address>, <Subnet Mask>, and <Gateway>, contact your network administrator.
4. In the <Port> pane, provide necessary information.
• HTTP Port : Used to access the NVR using the Internet browser, defaulted to 80.
Use the spin button to change the HTTP Port value.
• Port(TCP) : Used to control the video signal transfer, defaulted to 554.
5. Enter the password.
This is the login password for the “admin” user who accesses the NVR.
The default password is “4321”.
J
` The default password can be exposed to a hacking thread so it is recommended to change the password after installing the
product.
` Note that the security and other related issues caused by the unchanged password shall be responsible for the user.
6. Click [OK].
Manual network setup will be completed.
If using a Broadband Router
• IP Address : Enter an address falling in the IP range provided
by the Broadband Router.
ex) 192.168.1.2~254, 192.168.0.2~254, 192.168.XXX.2~254
• Subnet Mask : The <Subnet Mask> of the Broadband
Router will be the <Subnet Mask> of the NVR.
• Gateway : The <Local IP Address> of the Broadband Router
will be the <Gateway> of the NVR.
M
` The settings may differ depending on the connected Broadband
Router model.
For more information, refer to the user manual of the applicable router.
` Refer to the “Port Range Forward (Port Mapping) Setup” section of the Broadband Router’s documentation. (Page 24)
Auto Network Setup
Run <IP Installer_vX.XX.exe> to display the device search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
1. Select a NVR in the search list.
Both the [Auto Set] and [Manual Set] buttons will be activated.
2. Click [Auto Set].
The Auto Setting dialog appears.
The <IP Address>, <Subnet Mask>, and <Gateway> will be set automatically.