Filter
Top Products
English _95
● APPENDIX
Problem Action
Frame rate of the actual recording does not match
that of configured to the camera.
If multiple profiles were applied to one camera for video transmission, the
actual video stream can be serviced by the camera at a lower frame rate than
specified.
Configure your camera to use one profile for data streaming as possible.
For example, if you set the same profile for recording and network profiles,
the actual recording is made at the specified frame rate.
Note that allowed limit bitrate for recording / recording settings should be set
to be bigger values than that of camera’s feed.
Recording does not work.
If your player does not display a Live image at all, that indicates recording
does not work so first check if you see an image on the screen.
Recording does not work if the recording settings are not properly configured.
1) Press the
< >
icon on the Web Viewer’s Live tab to start
recording immediately.
2) Scheduled Record: Specify a desired time in Menu – Record –
Recording Schedule. Recording will start at the specified time.
- <Continuous> Record: Recording will proceed in any conditions at
the specified time.
- <Event> Record: When an event occurs, recording will perform only
if the event is of alarm, motion detection and video loss.
If there is no event found, recording will not perform.
- <Continuous / Event> Record: If there is no event found,
Continuous recording will perform. Whereas, if an event occurs,
Event recording will perform.
The image quality of the recording data is not good.
Increase the resolution and quality level in Menu – Record – Quality /
Resolution.
1) Resolution: Select a bigger size when specifying the recording size.
The recording image in the CIF format shows a deteriorated quality as
it is enlarged from a small-sized image.
2) Record Quality: Specify a bigger level for the recording quality.
If you increase the resolution and the recording quality, the data size increases
accordingly. So the HDD will be filled faster. Overwriting will overwrite the
existing data so recording will proceed at a shorter interval.