Filter
Top Products
70_ menu setup
menu setup
Event Record Duration
You can set the beginning and ending point of a recording on an event.
•
Pre Event : The recording of an event will start at a pre-determined time prior to the actual occurrence of the event.
If it is set to 5 seconds, the recording begins from 5 seconds before the event.
•
POST Event : The recording will continue for a pre-determined time after the actual end of an event.
If it is set to 5 seconds, the recording ends in 5 seconds after an event.
M
` If the video resolution is larger than 4CIF, recording may not proceed as much as the pre-event recording time.
The greater the video data size is, the maximum pre-event recording time will be reduced in inverse proportion.
Record Setting
You can set resolution, IPS, and quality of recordings by channel, and by recording type of standard / event.
You can check frame rates and data transfer amount of Full Frame and Key Frame recordings for each channel,
and set the transfer limit for recordings.
Setting NVR Recording
•
Standard, Event : Configures Standard recording and Event recording.
-
Full Frame : Records all frames fed by the camera.
-
Key Frame : Records only key frames fed by the camera.
Actual recording rate may differ from camera settings. In general, 1 to 2 frames per second are recorded.
-
OFF : No recording is made.