Filter
Top Products
BUILT-IN HARD DISK
Operating display
When the power for the digital video recorder is turned on, the operating display appears in the upper-left corner of the monitor screen. This
operating display shows information which is essential for operation, such as the date, time, picture quality and recording speed.
1
Camera number display
Connect the digital video recorder to a multiplexer that is capable
of decoding Sanyo’s channel information (camera number) and
press the CHANNEL button. The number of the specified camera
appear in the display during playback.
2
Date display
When the digital video recorder is first turned on, the date
appears as 01-01-01 (day, month, year). Make sure that you use
the menus to set the correct date.
3
Operating symbol display
These symbols appear during recording and playback.
a : Recording e : Fast forward
c : Playback f : Rewind
d : Reverse playback h : Stopped
hc : Slow playback dh : Slow reverse playback
Note: If recording and playback are being carried out at the same
time, the playback symbol (c) appears.
4
Amount of recording area remaining
If overwriting has been disabled (OVERWRITE: OFF) in the
normal recording area or alarm recording area, the amount of
space remaining appears as a percentage. You can change the
amount of recording area remaining using the RECORDING
CONDITIONS SET menu item. (See page 45.)
5
Alarm display and alarm number display
When an alarm setting is made using the ALARM REC MODE
SET menu item, The following display appears in the alarm
display.
However, the PRE display appears when pre-alarm recording has
been set. When an alarm occurs, the PRE is replaced by ALARM
and the number of alarms also appears. The alarm display shows
the cumulative number of alarms.
•
If ALARM RECORDING is set: ALARM appears.
ALARM flashes while an alarm is being recorded.
•
If PRE-ALARM RECORDING is set: PRE appears.
•
When playing images from the archive area: ARCHIV appears.
6
Time display
When the digital video recorder is first turned on, the time
appears as 00:00:00, and the time starts counting after the date
has been set. The digital video recorder uses the date and time to
control recording and playback, so if the date and time have not
been set, the correct images cannot be retrieved. Make sure that
you use the menus to set the correct time.
7
Picture quality display
This shows the picture quality for images that are recorded on the
hard disk. The default setting is EN (Enhanced). The display
changes when the picture quality is changed using the NORMAL
REC MODE SET menu item.
•
BA: Basic
•
NO: Normal
•
EN: Enhanced
•
FI: Fine
•
SF: Super Fine
8
Recording speed display
This displays the recording speed for images that are recorded
on the hard disk. The default setting is 0.12 SEC (during field
recording). The display changes when the picture quality and
recording method are changed using the NORMAL REC MODE
SET menu item.
01-01-01 ALARM 0000
00:00:00 EN 0.12SEC
4CH 100%
01-01-01 ALARM 0000
00:00:00 EN 0.12SEC
1
6
23 45
78
Note: During recording with this unit, playing back,
copying and transferring pictures is possible.
However, because of the recording priority the
response of the other operations becomes slower.
English
11