Filter
Top Products
RECORDING IMAGES IN THE ALARM RECORDING AREA
When an alarm is received, pre-alarm recording stops
automatically and the alarm images are recorded.
The “PRE” disappears from the operating display, “ALARM” flashes and the
ALARM indicator flashes.
Note: When the remaining area in the alarm recording area reaches 1%, the
ALARM FULL indicator on the front panel flashes. If recording is
continued under these conditions, the recording area is filled and the
recording stops.
In the RECORDING AREA SET settings, carry out the AREA FULL
RESET operation for the normal recording area.
Recording will then be possible from the beginning again. (See page
44.)
ALARM
4
10-06-01 ALARM 0000
09:30:15 EN 0.12SEC
POWER FULL
ALARM FULL
LOC
English
17