Filter
Top Products
HDD SET SETTING
HDD SET setting
To display hard disk capacity in DISK1 (on board) and DISK2 (for
addition)
Note: Before adding a hard disk, it is important to backup recorded
images on a media such as a CompactFlash card.
1
Press the MENU button twice to display the MAIN MENU 2
screen.
The cursor moves to DISPLAY SET/VIDEO LOSS SET.
2
Use the jog dial to move the cursor to the HDD SET
settings, and then turn the shuttle dial clockwise.
The HDD SET sub-menu appears, and the cursor moves to
DISK INITIALIZE.
3
Turn the shuttle dial clockwise.
A WARNING screen appears and then “NO” flashes.
4
Use the jog dial to select YES, and then turn the shuttle
dial.
The “HDD INITIALIZING!” screen appear and the hard disk is
initialized. Then the display is returned to the HDD SET
screen.
5
Press the EXIT/OSD button.
The display returns to the normal screen.
Adding a hard disk
Consult your dealer about adding a hard disk. In the case of an
addition, use an additional hard disk unit (sold separately).
If adding another hard disk, be sure to initialize the hard disks.
When this is done, both hard disks will be initialized, so that any
existing data on the original hard disk will be cleared.
Reference: HDD SET screen
•
MIRRORING: When a hard disk is added, it is possible to
record the same image on two hard disks. This means that
even if an image write error occurs you will be able to read from
an area where there is no write error. Note that if mirroring is
specified, the upper limit of recording speed will be limited.
•
PLAYBACK DRIVE: After MIRRORING has been set, you will
be able to specify which of the two hard disks is to be used for
reading the recorded image.
With mirroring setting, if an error has occurred in the playback
image, switch from the hard disk in current use (DISK1) to
(DISK2).
<HDD SET>
DISK1 : 80GB
DISK2 : ---GB
DISK INITIALIZE ->
CAUTION : ALL RECORDING WILL BE ERASED!
MIRRORING : OFF
PLAYBACK DRIVE : ¤¤¤
CAUTION : RECORDING SPEED WILL BE
LIMITED BY MIRRORING!
Main menu 2 Sub-menus
Initializes hard disk.
Records mirroring.
Sets the hard disk reading.
<MAIN MENU 2>
1.DISPLAY SET/VIDEO LOSS SET ->
2.RS-232C/RS-485 SET ->
3.BUZZER SET ->
4.SECURITY LOCK SET ->
5.NETWORK SET ->
6.HDD SET ->
7.POWER FAILURE/USED TIME ->
TO MAIN MENU 1 ->
MOVE LINES WITH JOG. SELECT WITH SHUTTLE
MENU
<HDD SET>
DISK1 : 80GB
DISK2 : ---GB
DISK INITIALIZE ->
CAUTION : ALL RECORDING WILL BE ERASED!
MIRRORING : OFF
PLAYBACK DRIVE : ***
CAUTION : RECORDING SPEED WILL BE
LIMITED BY MIRRORING!
<WARNING>
THIS CHANGE WILL INITIALIZE THE DISK.
ALL RECORDING WILL BE ERASED.
ARE YOU SURE ?
NO
CHANGE LINES WITH JOG. SELECT WITH SHUTTLE
HDD INITIALIZING !
EXIT/OSD
English
67