Filter
Top Products
34
Unit Settings
Setting the backlight
The LCD display’s backlight is preset at
the factory to activate whenever the
Remote Commander is operated, and to
switch off automatically if you do not
operate for more than 10 seconds. You
can set the backlight automatic-off time,
brightness, fade effect and which buttons
activate the backlight. To change this
setting, perform the following procedure.
1
While pressing the
COMMANDER OFF button,
press the MUTING button.
OFF
COMMANDER
MUTING
“SET” appears as the Display title.
SET
SU
LEARN
NG
LIGHT DISPLAY OTHER
If “LIGHT” does not flash on the
Label keys, press the Display title
(SET) repeatedly until it appears.
2
Press “LIGHT” on the Label keys.
LIGHT
“LIGHT” appears as the Display title.
LIGHT
SU
LEARN
NG
OFF_TIME LEVEL FADE ON_MODE
3
Press “OFF_TIME” on the Label
keys.
OFF
_
TIME
The setting display for automatic-off
time of the backlight appears.
LIGHT
SU
LEARN
NG
OFF_TIME (-) 10sec (+)
4
Press the (–) or (+) key to change
the automatic-off time of the
backlight.
You can set the automatic-off time
from 1 to 60 seconds. Each time the
(–)/(+) key is pressed, the time
decreases/increases by 1 second. For
example, “20sec” on the Label keys
means 20 seconds.