Filter
Top Products
49
Setting by On-Remote Setup
5 Press the key or button on the
Remote Commander you want to
“program” the preset code to.
“
LEARNLEARN
” flashes and only the pressed
key remains on the LCD display.
TV /1
SU
LEARNLEARN
NG
When you have programmed the
buttons on the Remote
Commander
The names of buttons not on the LCD display
(VOLUME +/–, CHANNEL +/–, MUTING,
RECALL, MENU, EPG, TOOLS, EXIT, F, f, g,
G and OK ) appear on the right Label keys.
To clear the learned signal from
a key or button
While pressing the SYNC-UP button,
press the learned key or button you want
to clear.
SYNC-UP
The cleared key flashes together with
other keys that are available for learning.
Learning up to 4 signals to one
key
This is useful when the Remote
Commander is not working properly,
even when the signal is learned for the
Remote Commander using the Learning
function. You can also use this function to
switch the input mode such as TV, etc., or
to switch between DVD player and DVD
recorder operation with one key.
To re-program already learned keys or
buttons, press the key or button while
pressing the LIGHT button.
INPUT
LIGHT
“
LEARNLEARN
” flashes and the only the pressed
key remains on the LCD display.
You can program a maximum of 4
functions to one key or button.
6 Press and hold the button on the
other remote control until you
hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
“
LEARNLEARN
” stops flashing and stays lit.
When the command has been learned
successfully, the learned keys stay lit
and the other keys available for
learning flash alternately.
Notes
• If “NG” flashes on the LCD display with
5 beep sounds, learning did not succeed.
Try again steps 5 and 6.
• If you touch a wrong key by mistake,
while pressing the SYNC-UP button,
press the incorrect key again.
Continued
Other remote control’s button