Filter
Top Products
47
Setting by On-Remote Setup
If you want to quit before
finishing
Press and hold the COMMANDER OFF button
for more than 2 seconds. The previous status
returns, and the Remote Commander turns off.
If you want to return to the
previous display
Press the BACK button or the COMMANDER
OFF button.
Notes
• If you enter a preset code that is not on the
table in the supplied “Preset Code Lists,” the
Remote Commander beeps five times. The
digits you input and “NG” appear on the
Label key after you press the OK button. The
previous setting returns. If this happens,
check the preset code, and try setting again.
• If you do not enter any data to the Remote
Commander for over 2 minutes between each
step, the setup procedure will be canceled. To
set the preset code again, press the MUTING
button while pressing the COMMANDER
OFF button.
• The first digit of the preset code means the
type of component (TV, VCR, etc.). The
component corresponding to the four-digit of
the preset code is set in step 5. If you register
a component whose type is different from
that previously preset to the Label keys, you
can, if necessary, change the component
names as the Label keys (page 65).
• If you set a preset code after you input
character contents (names, etc.) to the Label
keys (page 65), they are cleared and return to
the original display. Edit the characters after
you decide the component to be used by
setting a preset code.
• Except the DVD/Receiver combo (DAV), the
components with the built-in amplifier
should be registered as RCVR (Receiver). All
the keys that are inoperative should be
registered by the learning function.
Using non-preset
remote control
operations
– Learning function
To operate non-preset components or
functions, use the following “learning”
procedure to “program” any of the
programmable buttons and keys to
operate the functions of another remote
control. You can also use the Learning
function to change the signal of
individual keys and buttons after setting
the preset code (page 45).
Notes
•You cannot perform this procedure before
setting the preset code. Set the preset code
first.
• Some specific remote control signals may not
be learned.
• The learned signal may not work properly if
a target component’s remote control preset
button has two different functions for a single
press. If this occurs, program the two signals
for a Label key by referring to the “Learning
up to 4 signals to one key” on page 49.
• If you do not perform learning steps within 2
minutes, the learning process is cancelled.
Continued