Filter
Top Products
DisplayingTV status information
To display TV status information using RECALL:
Press @ on the remote control.
The following information will display (if applicable):
• Current input (ANT/CABLE, Video 1, etc.)
• If ANT/CABLE is the current input, either "CABLE" (for
cable TV) or "ANT" (for over-the-air broadcasts).
• Channel number (if in ANT/CABLE mode)
• Channel label (if set)
• Digital signal strength indicator (bar graph in lower right
corner of box; for ATSC signal only)
• Stereo, Mono or SAP audio status (when HDMI input mode,
Dolby Digital or PCM)
• Video resolution
• Aspect ratio of incoming video signal (4:3 or 16:9)
• V-Chip rating status
• GameTimer (if set)
• x.v.Color status of incoming signal
To close the RECALL screen:
Press _ again.
To display TV status information using INFO:
(only available for ANT/CABLE input)
Press _ on the remote control.
The following additional information will display for off air
digital channels (if applicable):
• Title
• Duration
• Detailed description
To display Next information, press _ on the remote control
again. Pressing _ a third time will remove the entire banner.
Note: The location of #)e banner can be moved to the top or
bottom of the screen by pressing • or • while the RECALL or
INFO display is on-screen. (The last position will be stored to
memory.)
Understandingthe auto power off
feature
The TV will automatically turn itself off after approximately
15 minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT/CABLE mode only.
Understandingthe last mode
memoryfeature
If the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the TV
when the power is resupplied.
Note:/f it's possible, and you will be away from the TV for an
extended period of time you should unplug the power cord.
6O