Filter
Top Products
inga DVD......... iorst VideO),a VCR,...........................................
and a satellite receiver
Your TV has two sets of ColorStream ® (component video) inputs.
0+-,
@
COMPONENTVIDEO S-VIDEO VIDEO
OUT OUT
DVDplayer withcomponentvideo
TVupperbackpanel
_ L_mu
From satellite dish
Satellitereceiverwithcomponentvideo TVlowerhackpanel
Stereo VCR
From antenna
You will need:
coaxial cables
standard A/V cables
- For better picture performance, if your VCR has S-video,
use an S-video cable (plus the audio cables) instead of
the standard video cable. Do not connect both types of
video cable to VIDEO 1 at the same time or the picture
performance will be unacceptable.
- If you have a mono VCR, connect L/MONO on the TV to
your VCR's audio out terminal using the white audio cable
only.
standard audio cables
component video cables
- You can connect the component video cables (plus audio
cables) from the DVD player or satetfite receiver to either
set of ColorStream terminals on the TV (HD 1or HD2). The
ColorStream HD1 and HD2 terminals can be used to
display Progressive (480p, 720p) and Interlaced (480L
1080i). Please check the Owner's Manual of the DVD
player or satellite in order to determine the best output
signal available (1080[) is not supported).
- If your DVD player or satellite receiver does not have
component video, connect a standard A/V cable to
VIDEO 2 on the side panel. If your DVD player has HDMI
video, see page 16.
To view antenna or Cable channels:
Select the ANT/CABLE video input source on the TV.*
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD1
video input source on the TV.*
14
To view satellite programs using the component video
connections:
Turn on the satellite receiver. Select the ColorStream HD2
video input source on the TV.*
To view the VCR or view and record antenna
channels:
Turn ON the VCR. Tune the VCR to the channel you want to
watch. Select the VIDEO 1 video input source on the TV.*
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to record.
Select the ColorStream HD1 video input source on the TV*
to view the DVD.
* To select the video input source, press INPUT on the remote control
(_+ page 21). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Laws of the United States and
other countries, and may subject you to civil and criminal
liability.